Dr. Pen A10 Cartridges

How to Use

1. To ensure there is no cross-contamination, cartridges must be sterilized before treatment.
2. Remove the cover on the top of the cartridge
3. Put together the cartridge to the Dr. Pen A10 Microneedling Pen
4. After double-cleansing the face and body area of treatment, dry it with a towel
5. Configure depth and speed according to your preferred treatment
6. Turn the pen on, then slowly start the treatment in small areas
7. Recommended to use Hyaluronic Acid to boost results
8. Recommended to use is a cross-hatch pattern
9. Only use light pressure and ensure not to drag or pull the skin

Usage

• Microneedling should be performed once every 4-6 weeks
• Safely dispose of your microneedling cartridge after one treatment

Important

• DO NOT USE one cartridge more than once for safety and hygiene reasons
• DO NOT USE in open wounds
• DO NOT USE on acne 
• DO NOT USE or continue to use if irritation happens
• Microneedling cartridges must be sterilized before each use to ensure the treatment is safe and hygienic. It is essential to follow these steps carefully to ensure that the microneedling cartridges are properly sterilized. Here are the steps to sterilize microneedling cartridges:

1. First, ensure that you have all the necessary equipment for sterilization; gloves, isopropyl alcohol solution (70% or above) and a clean container to hold the solution.
2. Put on your gloves to avoid contaminating the cartridges during the sterilization process.
3. Check on your cartridge; ensure the needles are in perfect condition (i.e. not bending) and remove any debris.
4. Pour enough alcohol solution into the container and dip the cartridge needle into a sterilisation container, then soak for a couple of minutes.
5. If you have alcohol solution in a spray model, you can spray it towards the needle head of the cartridge.
6. Once the sterilization is complete, allow the cartridge to air dry before using it.
7. Finally, your cartridge is ready for use.